The reverse row with dumbbells is a bent-over row with an underhand grip, palms facing forward. It works the latissimus dorsi, middle trapezius, rhomboids, posterior deltoids, and biceps, with the lower trapezius and erector spinae helping. The defining cue is simple: keep your back flat and your torso still, and drive your elbows back close to your sides toward your hips. The FitCraft app rates it Advanced. If you cannot keep your back flat, start with the one-arm supported row, or use lighter dumbbells and a more upright torso. Then progress to slower lowering, a longer squeeze at the top, and heavier dumbbells once every rep stays controlled.
Reverse rows are useful when you want a row that keeps your elbows close to your body. With your palms facing forward, your elbows travel back along your sides toward your hips, so you feel the pull through the sides of your back and between your shoulder blades, not only in your arms.
Quick Facts: Reverse Rows with Dumbbells
- Equipment needed: Pair of dumbbells
- Difficulty: Advanced (as rated in the FitCraft app); the one-arm supported row, rated Intermediate, is an easier exercise to start with
- Modality: Strength
- Body region: Back, shoulders and arms
Muscles Worked
The primary movers are the latissimus dorsi, middle trapezius, rhomboids, posterior (rear) deltoids, and biceps. The lats, along the sides of your back, draw your upper arms back toward your hips. The middle trapezius and rhomboids, between your shoulder blades, squeeze the shoulder blades together at the top. The posterior deltoids, at the backs of your shoulders, help pull your arms back, and the biceps bend your elbows as you pull. These muscles shorten as the dumbbells rise toward your hips and lengthen under control as you lower them.
The secondary muscles are the lower trapezius and erector spinae. The lower trapezius keeps your shoulder blades down so your shoulders don't shrug toward your ears. The erector spinae, the muscles along your spine, hold your back flat for the whole set while you are bent over.
The underhand grip changes the row path. With your palms facing forward, your elbows stay close to your sides and travel back toward your hips, which puts more emphasis on drawing the upper arms back and on the lats than a wide overhand grip does. Keeping the torso fixed stops momentum from replacing upper-back work.
Step-by-Step: How to Do a Reverse Row
- Set your stance and grip. Stand with your feet about hip to shoulder width apart and hold one dumbbell in each hand with an underhand grip: palms facing forward, away from your legs, with the handles running side to side.
- Hinge at the hips. Bend your knees, push your hips back, and hinge forward with a flat back until your torso is anywhere from about 45 degrees to nearly level with the floor, the dumbbells hanging under your shoulders. Go only as low as you can keep your back flat. If your low back rounds, stand a little taller or bend your knees more.
- Brace before you pull. Pull your ribs down, tighten your abs, and keep your neck in line, eyes on the floor a little ahead. Tip: choose dumbbells you can row without moving your torso.
- Row with your elbows. Breathe out and pull the dumbbells toward your hips and lower ribs by driving your elbows back close to your sides until they reach about the level of your back. A little elbow flare is fine. Keep your palms facing forward and squeeze your shoulder blades together without shrugging.
- Pause, then lower. Hold the squeeze for about a second, then breathe in and lower under control until your arms are nearly or fully straight. Keep your back flat and the hinge angle the same from first rep to last rep.
Common Mistakes and How to Fix Them
Rounding the Lower Back
What it looks like: Your spine curves as you hinge or as the set gets hard.
Why it's a problem: Rounding your back while you hold two dumbbells puts more load on your lower back.
The fix: Use lighter dumbbells, stand slightly more upright, and brace before every rep. If you still cannot keep position, switch to the one-arm supported row with a hand and knee on a bench.
Pulling With the Hands
What it looks like: You curl the dumbbells up with your arms instead of driving your elbows back.
Why it's a problem: Your shoulder blades and the sides of your back do less of the pull.
The fix: Start each rep by driving your elbows back toward your hips, and let your hands follow.
Heaving the Torso
What it looks like: Your chest pops up on every rep to help the dumbbells move, or you stand a little taller each rep until the hinge disappears.
Why it's a problem: Momentum makes the lift look stronger while the lats and upper back do less work.
The fix: Pause for one second at the bottom. If you need a torso swing to start the rep, lower the weight.
Shrugging at the Top
What it looks like: Your shoulders creep toward your ears as the dumbbells reach the top.
Why it's a problem: Your shoulders should stay down and back while you row. Shrugging lifts them toward your ears instead.
The fix: Keep the neck long and pull the elbows back, not up toward your ears.
Letting the Head Hang or Craning the Neck
What it looks like: Your head drops toward the floor, or you crane your neck up to look ahead.
Why it's a problem: Your neck ends up out of line with the rest of your spine.
The fix: Let your head follow your spine, with your eyes on the floor a little ahead of your feet.
Stopping the Range Short
What it looks like: Your elbows never reach your sides at the top, so the dumbbells stop well short of your waist.
Why it's a problem: Short reps cut out the squeeze between your shoulder blades at the top.
The fix: Row until your elbows reach about the level of your back, then lower until your arms are nearly or fully straight without losing your back position.
Get this exercise in a personalized workout
FitCraft, our mobile fitness app, uses its AI coach Ty to program compound strength exercises like this into your plan at the right volume and intensity, based on your level, goals, and equipment. Ty was designed and trained by Domenic Angelino, MPH (Brown University) and NSCA-CSCS, with research published in the Journal of Strength and Conditioning Research and Medicine & Science in Sports & Exercise.
Take the Free Assessment Free • 2 minutes • No credit cardReverse Row Variations: Regressions and Progressions
Supported Row (Intermediate)
Rest one hand and the same-side knee on a bench and row one dumbbell at a time with your free arm, so the bench supports your back. The supported row is the easier step when your back muscles are ready to pull but your hinge is not ready to hold two dumbbells. The FitCraft app rates it Intermediate.
Lighter Dumbbells and a More Upright Torso (Easier)
Keep the underhand grip and the flat back, but use lighter dumbbells and hinge a little less, so your torso sits nearer 45 degrees than level with the floor.
Two-Arm Reverse Row (Advanced)
The standard version described above: both arms pull together with an underhand grip while you hold the hip hinge. The FitCraft app rates it Advanced.
Bent-Over Rows
The same hinge with your palms facing back toward your legs, the grip of the FitCraft app's two-arm bent-over row, also rated Advanced. Your elbows angle out more, and a wide overhand grip leans a little more on the backs of the shoulders. A neutral grip, palms facing each other, is another valid row.
Inverted Rows
Use a bodyweight horizontal pull when you want to train the same broad pattern without loading the lower back with dumbbells.
Slower Lowering and a Longer Squeeze (Harder)
Lower each rep over about three seconds and hold the squeeze at the top for a second or two. You can also hinge a little lower, closer to level with the floor, or use heavier dumbbells, as long as your back stays flat.
No Dumbbells: Corner Row
This row needs a pair of dumbbells. Without them, the corner row trains the upper back with body weight: stand with your back to an inside corner and press your elbows into the walls.
When to Avoid or Modify Reverse Rows
Stop at any pain in a joint, your lower back or your neck. A burn in your upper back, the sides of your back, the backs of your shoulders or your biceps is normal. With any of the conditions below, see a doctor or physical therapist before you do reverse rows.
- Acute lower-back pain or a known disc problem. Holding the hinge keeps your lower back working for the whole set, and any lower back pain during a set means stop. Skip reverse rows and see a doctor or physical therapist first; they decide when you can train your back again.
- Recent spine, shoulder, hip, or elbow surgery. Get clearance from your surgeon or physical therapist before you do reverse rows; they decide how you return.
- Shoulder pain or a rotator cuff injury. Any shoulder pain or pinching means stop. See a doctor or physical therapist before you do reverse rows again.
- Uncontrolled hypertension or known cardiovascular disease. Get your doctor's clearance before you do reverse rows. Whenever you row, breathe out as you pull and never hold your breath.
- Pregnancy. The forward hinge gets awkward as the bump grows. Ask your doctor or midwife before you do reverse rows while pregnant.
- After giving birth, or with active diastasis recti. Get cleared by your doctor or a pelvic health physical therapist before you do reverse rows; they decide how you return.
Related Exercises
- Same muscle group: Bent-Over Rows and Overhead Pullover train pulling muscles with dumbbells.
- Bodyweight pull options: Inverted Rows let you train a horizontal pull without a loaded hinge, and the Corner Row trains the upper back with no equipment at all.
- Hinge complement: Romanian Deadlift trains the hip hinge you hold during the row.
- Core foundation: Deadbugs and Forearm Planks are core exercises to pair with rows, and Bird-Dogs train the glutes and the muscles along your spine.
How to Program Reverse Rows
Ratamess et al., 2009 summarizes ACSM resistance-training progression models that scale sets, reps, rest, and frequency by training level. The paper gives no set and rep ranges for the reverse row itself, so treat the table below as a practical starting point.
| Level | Sets × Reps | Rest between sets | Frequency |
|---|---|---|---|
| Easier (supported row, or lighter dumbbells and a more upright torso) | 2-3 × 8-12 | 90-120 seconds | 2-3 sessions/week |
| Advanced (two-arm reverse row, as rated in the app) | 3-4 × 6-12 | 120-180 seconds | 2-4 sessions/week |
| Harder (slower lowering, longer squeeze, or heavier dumbbells, back flat) | 3-5 × 6-10 with strict control | 120-180 seconds | 2-4 sessions/week |
Place reverse rows early in an upper-body or full-body strength session, usually after the warm-up and before smaller isolation work. They pair well with dumbbell presses or shoulder presses.
Stop the set when the torso starts moving, the low back rounds, or the elbows stop reaching your sides. Good form matters more than hitting a planned number of reps.
FitCraft, our mobile fitness app, places pulling and compound strength exercises at the right point in your plan based on your level, goals, and equipment. The app has one reverse row, both arms together with an underhand grip, rated Advanced, with an interactive 3D demonstration, and it includes the supported row (Intermediate) as its own exercise.
Frequently Asked Questions
Can I do reverse rows with lower-back pain?
Not while it hurts. Holding the bent-over position keeps the muscles along your spine working for the whole set, and any lower back pain during a set means stop. If your lower back hurts, see a doctor or physical therapist before you do reverse rows again.
What muscles do reverse rows work?
Reverse rows with dumbbells primarily work the latissimus dorsi, middle trapezius, rhomboids, posterior deltoids, and biceps: the lats draw your upper arms back toward your hips, the middle trapezius and rhomboids squeeze your shoulder blades together, the posterior deltoids help pull your arms back, and the biceps bend your elbows. The lower trapezius and erector spinae help: the lower trapezius keeps your shoulders down, and the erector spinae, the muscles along your spine, hold your back flat while you are bent over.
What's the difference between a reverse row and a bent-over row?
The difference is the grip. In a reverse row your palms face forward, away from your legs, so your elbows stay close to your sides and your arms pull back toward your hips; an underhand grip puts more emphasis on drawing the upper arms back and on the lats. The bent-over row in the FitCraft app uses palms facing back toward your legs, which angles the elbows out more, and a wide overhand grip leans a little more on the backs of the shoulders. The app rates the reverse row and the two-arm bent-over row Advanced, and a neutral grip, palms facing each other, is a valid row of its own.
How heavy should reverse rows be?
Choose a load you can row for clean sets of 6 to 12 reps while keeping your torso still. If your back rounds, your torso bounces, or your elbows stop reaching your sides, the dumbbells are too heavy.
Are reverse rows good for posture?
There is no direct evidence that reverse rows improve posture: no study we found tested them for it. They do strengthen the sides of your back, the muscles between your shoulder blades, the backs of your shoulders and your biceps.